Gary | Sales Tel: 69580100-80824 hour free service hotline: 17749768756 Fax: 021-69580100-816 QQ: 2477229652 Mail: 2477229652@qq.com fluorocarbon finish 553CE base: 553C7 hardener: 953CE Overview: fluorine Carbon finish 553CE is a two component room temperature curing fluorocarbon coating, with superior gloss and color retention. Adhesion resistance to scrub. Due to low surface energy, the film has good stain resistance and easy to clean features. Uses: used as a protective and decorative finishes in serious pollution of the environment on the film gloss, color retention, high steel and cement surface. . Minimum curing temperature is -10 ° C Physical parameters: Color / Color: White / 10000 (available in other colors on request) paint: light volume solids content: about 46% of the theoretical spreading rate: about 15.32 / liter (to 30 microns dry basis) Flash Point: 23 ° C Specific Gravity: about 1.2 kg / liter Dry to touch: about 2 hours (20 ° C) (ISO1517) fully cured: 7 days (20 ° C) VOC: Approx. 485 g / liter content (VOC): Shelf life: storage environment requires a cool, dry. Production date, the product shelf life is one year (20 ° C) Note: Temperature: Use the temperature exceeds 100 ° C, the film becomes soft, in addition, may be slightly discolored. Film thickness: Depending on purpose and area, you can use non-recommended film thickness finish, while the spreading rate, drying time and recoating time is also changed accordingly. Use airless spray, dry film thickness Greaves sprayed once formed is not more than 35 microns thinner: thinner depending on the type and amount of construction conditions, construction method, temperature, ventilation and substrate conditions. In general, we recommend using Hempel Thinner 014CN. Air Spray: the amount of diluent is recommended 40-50%, Tu 4 cup spray viscosity of about 14-16 seconds. In some special cases, the amount of diluent may be more than 50% in order to ensure the paint in a satisfactory condition. First spray chart clothes, 2-15 minutes to complete the film thickness during spraying, recoat interval and drying / curing time: recoat interval and drying / curing time and after the exposure conditions. Construction of the surface temperature of 0 ° C 10 ° C 20 ° C 30 ° C dry to the touch (about) 36 hours 16 hours 8 hours 6 hours to fully cure (relative humidity: 70%) 32 days 14 days 7 days 5 days recoat ( weight coated) Minimum 3 days 32 hours 16 hours 12 hours To recoat (weight coated) Maximum no no no no under any circumstances absolutely require surface plot to ensure interlayer. Especially in the case of long recoating intervals. With a suitable cleaning agent to remove surface all dirt, grease and the like. Then high pressure fresh water wash salt track surface. In order to ensure that the surface sufficiently clean, affect a small area before taking formal recoating. Note: hardener 953CE is extremely sensitive to moisture, the lid should be sealed and stored in a dry place. Unpacking the curing agent barrel caution as hypertension. Paint mixing process, a small amount of water will shorten the trial period and the resulting hybrid film defects.