Hempel epoxy zinc-rich primer 171CE base: 171CE hardener: 971CE Overview: Hempel epoxy zinc-rich primer 171CE is a two component epoxy zinc-rich paint. Curable form a tough, corrosion-resistant paint. Uses: 1, as "VOC-compliant" products for the steel surface moderately to severely corrosive environment. Can also be coated with zinc shop primer for steel surfaces - before coating, the surface of the damaged area of ??steel, welds, etc. must be cleaned first with a power tool. 2, the construction site for the container, the product of zinc content in line with SSPC-Paint20, the provisions of type2, level3; the physical parameters: Color / Color: Red Grey / 19830 finish: Semi-square Volume Solids: 66 + 1% of the theoretical Coverage: 13.22 / liter (50 microns dry basis) Flash Point: 24 ° C Specific Gravity: 2.3 kg / liter Dry to touch: about 3 hours (20 ° C) (ISO 1517) is fully cured: 7 days (20 ° C) VOC: 324 g / l content (VOC): Construction Description: Surface treatment: New steel: with an appropriate cleaner to remove oil and grease etc. thoroughly. By (high pressure) fresh water to clear salt and other contaminants. Abrasive blasting to Sa2.5 level. As a temporary protection, if necessary, use a suitable zinc shop primer. Before construction, all the storage and assembly process damaged shop primer and contaminants must be removed, the FDA can be repaired and painted up. Patch: complete with an appropriate cleaner to remove grease and dirt. By (high pressure) fresh water to clear salt and other contaminants. The best way to use dry sand to clear rust and other loose material. Can be used to clean a small area power tool. Note: VOC-EU Directive 2004/42 / EC: Product undiluted 15% dilution volume two-stage limited, 2012 171CE19830 324 g / liter 404 g / liter 500 g / liter stirred: the before and hardener mix, stir base , prevent possible sedimentation after storage. Once mixed, it should keep stirring the paint, maintain uniform so before it runs out. It is very important, in case of transition after dilution or mixing dead time is too long, there is a risk of too much zinc dust settling. Construction: Use proper detergent to clean surface dirt, grease, or other foreign matter, and then use (high pressure) fresh water rinse. In addition, the application of a new hard brush corrosion products (white rust). Thickness / Dilution: to change the designation of the film thickness, it will lead to the spreading rate, drying time and recoating interval. The normal range of dry film thickness of 50-75 microns. (For rough surfaces, dry film thickness range does not consider the correction factor, as the ISO 19840.) A Hezuo industrial protective coatings (Shanghai) Co., Ltd., established in 2006, is a professional import Shanghai industrial protective coatings, civil protective coatings company, set sales, construction, and technical support for the integration guide. For the country to provide high quality, environmentally friendly protective coatings. Free hotline: 4001-085-08024 hours Order Tel: 177-4976-8756 Contact:? Gary company's official website: www.akhzo.com